Reed Selection Calculator
Correct reed dent from sett and threading pattern.
Inputs
Results
Recommended reed (dent/inch)
4
Ends per dent
3
Actual EPI12
EPI deviation %0
Total dents used80
Total warp ends248
How to Use This Calculator
- Enter your target ends per inch (EPI) for the project's warp sett.
- Enter the total warp width in inches on the loom.
- Enter the number of extra selvedge ends per side for edge durability.
- Read the recommended reed size (dents per inch) and the number of ends to thread per dent.
- If the ends-per-dent is fractional, alternate between denting patterns — for example, alternate 1 and 2 ends per dent.
- Check the actual EPI and EPI deviation to verify the reed choice meets your sett target.
Ad Placeholder
Ad Placeholder